Escape 2WD V6-3.0L (2009)
4. NOTICE: Make sure not to pinch the Output Shaft Speed (OSS) or Transmission Range (TR) sensor wiring harnesses when installing the
main control.
NOTE: Install the different length bolts in the locations noted during disassembly.
Install the main control and the nut and 22 bolts. Tighten in a crisscross pattern.
-
Tighten to 10 Nm (89 lb-in).
5. Route the OSS sensor wiring harness and connect the electrical connector.
6. Connect the TR sensor electrical connector.
7. Install the main control-to-main control cover grommet.
8. Clean the main control cover sealing surface and inspect for damage.
