Escape 2WD V6-3.0L (2009)
Installation
1. Install the OSS sensor and the bolt.
-
Tighten to 10 Nm (89 lb-in).
2. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Main Control Valve Body See: Automatic
Transmission/Transaxle/Service and Repair/Overhaul/Disassembly And Assembly Of Subassemblies/Main Control Valve Body. If installing a new
main control assembly, continue with this procedure.
Position the OSS and TR sensor wiring harnesses aside and install the main control-to-transaxle separator plate.
3. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.
Install the main control.
