Escape 4WD L4-122 2.0L DOHC VIN B SFI (2001)
1.
Open the hood and locate C134 (Figure 1).
2.
Disconnect the connector halves and thoroughly inspect the terminals. Clean any corrosion that may be present and replace any damaged
terminals.
3.
Use shop air to blow out any moisture that may be present in the terminals, then apply dielectric grease to the terminals in both halves of the
connector.
4.
Reconnect the connector halves and close the hood.
C263
1.
Open the drivers door and remove the lower kick panel.
