Escape 4WD L4-2.3L VIN H Hybrid (2005)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Wrench Lamp ON/DTC PA01F Stored
TSB 05-5-13
03/21/05
WRENCH LAMP ON WITH DTC P0A1F PRESENT IN
TBCM AND/OR PCM MODULES - VEHICLES BUILT
8/2/2004 THROUGH 1/26/2005
FORD:
2005 Escape Hybrid
ISSUE
Some 2005 Escape Hybrid vehicles may exhibit a caution (wrench) lamp on and diagnostic trouble code POA1F in the powertrain control module
(PCM), and/or the traction baffery control module (TBCM).
ACTION
Reprogram the TBCM to the latest calibration. Refer to the following Service Procedure.
SERVICE PROCEDURE
WARNING
THE BATTERY CONTAINS HIGH-VOLTAGE. HIGH-VOLTAGE INSULATED SAFETY GLOVES AND FACE SHIELD MUST BE WORN
WHEN COMING IN CONTACT WITH THE HIGH-VOLTAGE BATTERY.
CAUTION
BEFORE ATTEMPTING ANY REPROGRAMMING TO THE TBCM REMOVE THE HIGH VOLTAGE BATTERY SERVICE DISCONNECT
FUSE, PLACE THE FUSE IN THE POSITION LABELED "SERVICE" ON THE FUSE LABEL.
1.
With the key in the OFF position, remove the high voltage baffery service disconnect fuse, and place it in the "Service" position.
2.
Turn the ignition key to the ON position.
3.
Reprogram the TBCM to the latest calibration using WDS release B36.2, Patch 3 or higher. Calibration files may also be obtained at the website.
4.
Turn ignition key switch to the OFF position.
5.
Place the high-voltage service disconnect fuse in the position labeled "Lock".
6.
Turn the ignition key to the ON position.
7.
Using WDS, clear DTCs in all modules.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
050513A
2005 Escape Hybrid Check
0.5 Hr.
For Diagnostic Trouble
Codes And Reprogram
The TBCM (Includes Time
To Clear Codes) (Do Not
Use With 12650D,
12650D84, 12651D,
12651D4)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
14C197
04
