Escape 4WD L4-2.5L (2010)
Sunroof / Moonroof Track: Service and Repair
Trough Assembly
Trough Assembly
Removal and Installation
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including:
whenever the roof opening panel motor has been removed from the roof panel system, the roof opening panel glass has been removed from the roof
opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new
roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening
Panel Motor Initialization See: Testing and Inspection/Programming and Relearning.
1. Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass See: Sunroof / Moonroof Panel/Service and
Repair/Roof Opening Panel Glass.
2. Remove the 2 roof opening panel drain channel screws and the drain channel.
3. To install, reverse the removal procedure.
-
Verify that the roof opening panel is centered and aligned before tightening the glass screws. For additional information, refer to Roof Opening
Panel Alignment See: Adjustments.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
