Escape 4WD L4-2.5L (2010)
Disassembly and Assembly
Both rear seat backrests
1. Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Rear See: Seat Cover/Service and Repair/Seat
Backrest Cover - Rear.
2. Remove the backrest foam pad from the backrest frame.
Sixty percent seat backrest
3. Release the seat latch cable from the center safety belt retractor.
-
For installation, make sure the rear safety belt retractor is not in the Automatic Locking Retractor (ALR) mode after installation. For additional
information, refer to Restraint Systems.
4. Remove the 2 nuts and safety belt guide.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the nut and center safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
Both rear seat backrests
6. Remove the 2 bolts and backrest latch.
