Escape 4WD L4-2.5L (2010)
Seat Cushion: Removal and Replacement
Seat Cushion Cover - Rear
Seat Cushion Cover - Rear
Removal and Installation
1. Remove the rear seat cushion.
-
Position the seat cushion forward.
-
Release the locking tab and slide the rear seat cushion outward.
2. Unzip the cushion cover zipper.
3. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn
from the seat cushion foam pad.
Invert and remove the cushion cover.
4. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
Seat Cushion - Front
Seat Cushion - Front
Removal and Installation
NOTICE: To prevent system failure, it is necessary to carry out the Occupant Classification Sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS
system reset command.
NOTE: For component identification and locations, refer to Seat - Exploded View, Front See: Service and Repair/Seat - Exploded View, Front.
All seats
