Escape 4WD L4-2.5L (2010)
5. Remove the 4 seat track-to-cushion frame bolts.
6. If equipped, disconnect the heated seat system components.
-
Disconnect and detach the cushion heater mat electrical connector.
-
Release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
-
Disconnect the heated seat relay electrical connector.
Seat with original equipment Occupant Classification Sensor (OCS) system
7. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
NOTE: To identify between a production OCS system and a service OCS system (OCS service kit), inspect the electrical connector. A
production OCS system allows the disconnect of the OCSM electrical connector. A service OCS system (OCS service kit) has the electrical
connector glued to the OCSM. It cannot and should not be disconnected or altered.
Disconnect the electrical connectors and wiring clips.
1. Disconnect the OCSM electrical connector.
2. Disconnect the pressure sensor electrical connector.
-
Detach the wiring harness retainers and wiring harness from the cushion frame.
8. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn
from the seat cushion foam pad.
Release all cushion cover retainers and remove the cushion cover.
9. Remove the cushion foam pad.
10. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
11. NOTICE: Care must be taken to prevent damage to the seat cushion frame when removing the rivets.
Remove the 2 rivets and the OCSM.
