Escape 4WD L4-2.5L (2010)
6. Remove the 4 brake booster nuts.
-
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the brake pedal and bracket assembly.
-
Position the brake booster forward to allow the brake pedal and bracket assembly to clear the brake booster studs.
8. NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.
