Escape 4WD L4-2.5L (2010)
Oil Pick Up/Strainer: Service and Repair
Oil Pump Screen and Pickup Tube
Oil Pump Screen and Pickup Tube
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View See: Oil Pan/Service and
Repair/Engine Lubrication Components - Exploded View and Oil Pan See: Oil Pan/Service and Repair/Oil Pan.
3. NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
Remove the 2 bolts and the oil pump screen and pickup tube.
-
To install, tighten to 10 Nm (89 lb-in).
4. To install, reverse the removal procedure.