Escape 4WD L4-2.5L (2010)
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing, a new safety
belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original
structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching
hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Remove the 60 percent seat backrest. For additional information, refer to Seats.
2. Remove the head restraints.
3. Remove the 2 screws and the latch cover.
4. Remove the 2 seat latch release lever screws.
5. Remove the seat latch release lever.
1. Detach the latch rod from the seat latch release lever.
-
To aid installation, lock the latch using a flat-blade screwdriver before connecting the latch rod.
2. Remove the seat latch release lever.
6. Remove the 2 screws and safety belt shield.
7. Release the backrest trim cover J-clip.
8. Unzip the backrest trim cover zipper.
9. NOTE: The inboard and outboard head restraint guides are not interchangeable.
Pull up and remove the 4 head restraint guides.
-
Note the alignment tab position for correct installation.
10. NOTICE: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
