ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5373 > < Initial Inspection and Diagnostic Overview|Page 5371
Page 5
background image

No

REPAIR the affected circuit(s). TEST the system for normal operation.

-------------------------------------------------
B4 CHECK THE AC POWER POINT LED

-

Test the diode between AC power point C2292-5, component side and AC power point C2292-6, component side in both directions.

-

Is the resistance greater than 10,000 ohms in one direction and between 10-20 ohms in the opposite direction?

Yes

INSTALL a new DC/AC inverter. REFER to Direct Current/Alternating Current (DC/AC) Inverter  See: Service and Repair/High Voltage
Converter/Inverter/Direct Current/Alternating Current (DC/AC) Inverter. TEST the system for normal operation.

No

INSTALL a new AC power point. REFER to Alternating Current (AC) Powerpoint  See: Service and Repair/High Voltage
Converter/Inverter/Alternating Current (AC) Powerpoint. TEST the system for normal operation.

-------------------------------------------------

Pinpoint Test C: The DC/DC Converter Does Not Operate Correctly

High-Voltage Converter/Inverter

Pinpoint Tests

Pinpoint Test C: The DC/DC Converter Does Not Operate Correctly

Refer to Wiring Diagram Set 12 (Escape/Mariner, Escape Hybrid/Mariner Hybrid), Charging System for schematic and connector information.  See:
Diagrams/Electrical Diagrams/Diagrams By Number

Normal Operation

The DC/DC converter is a liquid-cooled component that converts high voltage (216-397 volts) DC power to low voltage (12 volts) DC power while
maintaining electrical isolation between the 2 DC power systems. The converter steps down the high voltage to 12 volts, providing power to the vehicle
low voltage battery system. The PCM controls the operation of the DC/DC converter through an enable input from the PCM to the DC/DC converter.

This pinpoint test is intended to diagnose the following:

-

PCM

-

12-volt battery

-

Battery cables

-

DC/DC converter

PINPOINT TEST C: THE DC/DC CONVERTER DOES NOT OPERATE CORRECTLY

-------------------------------------------------
C1 CHECK THE PCM FOR DTCs

-

Enter the following diagnostic mode on the scan tool: Self Test/Retrieve and Record On-Demand and Continuous Memory Diagnostic Trouble
Codes (CMDTCs).

-

Are any PCM DTCs present?

Yes

Initial Inspection and Diagnostic Overview|Page 5373 > < Initial Inspection and Diagnostic Overview|Page 5371