Escape 4WD L4-2.5L (2010)
retention of these parts.
1. Remove the rear quarter trim panel.
2. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
3. Using a suitable jackstand, support the rear suspension.
4. Remove and discard the upper shock absorber nut and bushing assembly.
-
To install, tighten the new nut and bushing assembly to 40 Nm (30 lb-ft).
5. Remove and discard the lower shock absorber nut, washer and bolt.
-
To install, tighten the new nut to 175 Nm (129 lb-ft).
6. Remove the shock absorber.
7. To install, reverse the removal procedure.
