Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Front Bumper Cover / Fascia: Service and Repair
FRONT BUMPER COVER
Removal and Installation
1. Raise and support the vehicle.
2. Remove the six pin-type retainers (three each
3. Remove the foul front bumper cover bolt (two each side).
4. Remove and discard the two front bumper cover-to-front fender pin-type retainers (one each side).
5. If equipped, disconnect the fog lamp electrical connectors.
6. Remove the lower front bumper cover bolts.