Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
7.
Remove the liftgate latch release rod and install the new rod. See Figure 6.
8.
Remove the original release rod clip and replace with the new clip.
LIFTGATE LATCH INSTALLATION
AFFECTED VEHICLES: ALL VEHICLES COVERED BY 04C09
1.
Position the latch assembly in the vehicle.
2.
Apply Motorcraft Medium-Strength Threadlocker TA-25 (blue) to the bolts and install the three (3) liftgate latch bolts. See Figure 7.
3.
Tight the bolts to 5 Nm (44 lb-in).
4.
Connect the liftgate ajar switch electrical connector.
NOTE:
Fore 2001-2004 model year vehicles, proceed to Liftgate Handle Installation.
For 2005 model year vehicles, continue with Step 5 of this procedure.
5.
Install the liftgate trim panel and four (4) screws.
6.
If equipped, install the rear wiper motor cover.
7.
Close the liftgate.
