Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
1.
Locate new push-pin holes (See Figure 1 for example locations).
2.
Cut template along the curves printed on both sides of template.
3.
Make two holes on template along the printed circles.
4.
Align template with glass and C-pillar or D-pillar as noted on template. Make sure arrow points to front of the vehicle. Use template for locating
proper push-pin spacing (Figure 2).
5.
Fit the D-pillar side edge as noted on template and the D-pillar to locate the new push-pin positions between D-pillar and C-pillar (Figure 2).
6.
Mark both left-hand side and right-hand side new pin position holes as noted on template. Make sure arrow points to front of the vehicle.
