Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
15. Disconnect the driver air bag module electrical connector.
16. Connect the special tool to the steering column harness side of the driver air bag module electrical connector.
17. Connect the battery ground cable.
18. Prove out the air bag system.
19. Remove the seat track to floor nuts.
20. Position the driver seat rearward.
21. If equipped with power seats, disconnect the negative battery cable.
22. CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle
may result in damaged components.
Remove the driver seat.
1
Remove the seat track to floor bolts.
2
Remove the driver seat.