Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
USING DIFFERENT TOOLS MAY RESULT IN A POOR QUALITY REPAIR. See Figure 16.
PROCEDURE TO REPLACE VEHICLE HARNESS CONNECTOR
1. Remove the tape and the convolute from the vehicle harness which leads up to the ABS module connector. See Figure 17.
2. Measure approximately 75 mm (3 in) from the end of the elbow towards the ABS module connector, then, using suitable wire cutters, cut the harness
(all wires) to the same length. See Figure 17.
