Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
A flow chart has been developed to help direct you to the proper repair. See Figure 1.
Inspect Connector Seals
INSPECTION
1. Disconnect the battery negative terminal.
2. NOTE: When disconnecting the ABS module connector, be sure the blue connector lock stays engaged with the harness connector and does not
remain in the module. Remove it from the module if necessary and make sure the white 0-ring seal is properly installed.
Disconnect the ABS module 25-pin connector by sliding the lock mechanism out (towards the passenger side of the vehicle) and pulling the
connector off the module.
3. Disconnect the speed sensor harness, then remove the 2 harness retainers from the studs and position the harness above the air cleaner assembly to
provide access for inspection.
4. Inspect the top of the ABS module connector cover for 2 yellow "X" marks.
^
If 2 yellow "X" marks are present, perform Labor Operation F - Install New ABS Module and Apply Electrical Grease.
^
If no yellow "X" marks are present, proceed to Step 5.
