Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
7. Verify the wire seals are present on the 4 heavier gauge wires. See Figure 4.
8. Verify the numbers 054" are stamped on the slide-lock end of the mat cover (wipe the mat cover clean if necessary to view). See Figure 5.
NOTE:
Mat covers with any other number will be missing plugs in the unused pin locations.
9. Perform Labor Operation C - Install Pigtail and Apply Electrical Grease if:
^
any seals are missing or,
^ if the number on the mat cover is not "054".
10. Perform Labor Operation D - Seat Connector and Apply Electrical Grease if:
^
Any of the 4 wire seals are not fully seated in the connector cavities.
^
Each seal should sit approximately 1-2 mm (1/16 in) below the top of the round cavity. See Figure 4.
11. Perform Labor Operation A - Apply Electrical Grease if:
