Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2
Release the upper return spring.
3
Remove both brake shoes together.
7. WARNING: Use of any other than approved DOT 4 or DOT 3 brake fluid will cause permanent damage to brake components and will
render brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
NOTE: When any part of the hydraulic system has been disconnected for repair or replacement, air may get into the system and cause spongy
brake pedal action. This requires the bleeding of the hydraulic system after it has been correctly connected.
Disconnect the brake line fitting from the wheel cylinder.
8. Remove the wheel cylinder.
1
Remove the bolts.
2
Remove the wheel cylinder.
9. To install, reverse the removal procedure.
^
Bleed the brake hydraulic system.
