Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
5. Inspect the ABS module connector pins for corrosion. See Figure 2.
^
If corrosion is present, perform Labor Operation E - Install Pigtail, New ABS Module and Apply Electrical Grease.
^
If corrosion is not present, proceed to Step 6.
6. CAUTION: Do not cut any of the harness wires or the wire insulation when cutting off the tie strap.
Remove the tie strap from the connector dress cover, then slide the cover off the connector. See Figure 3.
