Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Brake Switch (Cruise Control): Service and Repair
REMOVAL
1. Remove the deactivator switch.
1
Disconnect the electrical connector.
2
Rotate counterclockwise 45 degrees and remove the deactivator switch.
INSTALLATION
CAUTION: Initial installation of a deactivator switch allows for one adjustment. If additional adjustments are required, install a new switch.
1. Release the plunger lock.
^
Turn the lock knob counterclockwise until the first click is felt.
2. Depress the brake pedal.
3. Install the deactivator switch.
1
Position the deactivator switch in the bracket and rotate clockwise 45 degrees.
2
Connect the electrical connector.
4. Slowly release the brake pedal and tug moderately once the pedal reaches the rest position.
NOTE: There should be an extra click heard when tugging on the brake pedal.
