Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2. CAUTION: The OEM pulley is pressed on 4.74 mm (0.18 in.) past flush of the end of the camshaft. The service pulley is pressed on flush to the
end of the camshaft.
Using the special tools, remove the water pump drive pulley and discard.
3. Remove the timing drive components.
4. NOTE: To make sure of correct sealing, do not scratch the camshaft.
Using the special tools, remove the camshaft oil seal and discard.
5. Remove the bolts, the camshaft oil seal retainer and discard the press-in-place gasket.