Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
5. Separate the harness from the center locating pins and position aside.
6. Disconnect the crankcase ventilation tube from the valve cover.
7. Remove the bolts, studs and the RH valve cover.
-
Remove and discard the gasket.
Installation
1. NOTE: Clean the valve cover sealing area before installing a new gasket.
Install a new valve cover gasket.
2. NOTE: Clean the head and front cover sealing surfaces using metal surface cleaner before applying silicone gasket and sealant.
NOTE: The valve cover must be installed and the bolts tightened within four minutes of applying the sealant.
Apply a 5 mm dot of silicone gasket sealant to the front cover to cylinder head joints
