Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Fog/Driving Lamp Switch: Service and Repair
FOG LAMP SWITCH
REMOVAL
1. Disconnect the battery ground cable.
CAUTION: Do not use a screwdriver to remove fog lamp switch or damage to the finish panel may occur. Adding tape to the end of a
thin tool will reduce marring to the finish panel.
2. Use a thin tool to remove the fog lamp switch.
3. Disconnect the electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.
