Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
5. Disconnect the 16-pin electrical connectors.
6. Disconnect Power Steering Pressure (PSP) switch electrical connector.
7. Disconnect the six fuel injector electrical connectors and release the wiring harness locators from the fuel injection supply manifold.
NOTE: One connector is shown, the other five connectors are similar.
8. Disconnect the Camshaft Position (CMP) sensor electrical connector.
9. Remove the RH wheel and tire assembly.
10. Remove the RH lower splash shield.