Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
15. Connect the passenger air bag module electrical connector.
16. Close the glove box.
17. Remove the restraint system diagnostic tool from the clockspring electrical connector at the top of the steering column.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
18. Connect the driver air bag module electrical connector.
19. Install the steering wheel access cover.
20. Connect the battery ground cable.
21. With all the restraint system diagnostic tools removed, prove out the air bag system. See: Air Bag(s) Arming and Disarming/Service and
Repair/Prove Out Procedure
