Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
9. Route the side air bag module wire harness as noted in removal. Install the wire harness and electrical connector pin-type retainers.
10. Install the outboard seat cushion side shield.
1
Align the retaining clips and push inward, seating the retaining clips.
^
If equipped, connect the power seat switch electrical connector.
2
Install the screw.
3
Install the seat backrest lever cover.
11. Install the seat cushion adjuster handle.
12. Install the seat cushion adjuster handle center plug.