Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2
Install the two pin-type retainers (one shown).
3
Close the cover.
15. Position the seat cushion down.
Vehicles with a rear power point
16. Connect the battery ground cable.
All vehicles
17. Check the active restraint system for correct operation.
1
Make sure that after the rear safety belt retractor is installed, the retractor is not in the Automatic Locking Retractor (ALR) mode.
2
Carry out the Emergency Locking Retractor (ELR) Mode Functional Test to make sure that the new retractor operates correctly. See: Testing
and Inspection/Component Tests and General Diagnostics