Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
8.
Remove top portion of left hand D-pillar trim to allow headliner to flex down. Be careful not to bend or over flex headliner too much or creasing
will occur (Figure 4).
9.
Rotate electrical connector 90 degrees. Pull harness toward rear of vehicle to avoid drill damage (Figure 5).
10.
Install protective tubing sleeve onto 7 mm (9/32 inch) drill bit with 7-10 mm of the drill bit exposed beyond the end of the tube (Figure 6).
NOTE
THIS SLEEVE MUST BE USED TO PREVENT DAMAGE TO THE ROOF.
