Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2
Install the nut.
4. Install the upper engine insulator bracket bolt.
5. Position the A/C line support and install the nut.
6. Using the special tool, install a new seal on the power steering pressure hose fitting.
^
Remove and discard the original seal.
^
Stretch the seal over the special tool and slide it onto the tube nut.
7. Connect the power steering pressure hose.
1
Connect the power steering pressure hose to the pump.
2
Connect the electrical connector.
3
Install the power steering pressure line bracket bolt.