Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
1. NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.
Install the OSS sensor.
^
Connect the OSS sensor electrical connector.
2. Install the splash shield.
3. Install the LH front wheel.
4. Lower vehicle.
5. Check the transmission fluid level, add fluid as necessary using MERCON(R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting
MERCON(R) V specification.
6. Start the engine and move the transaxle range selector lever through all gear positions.