Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
3. WARNING: The clutch disc and clutch pressure plate are heavy and may fall if not held when the bolts are removed. Failure to follow
these instructions may result in personal injury.
CAUTION: Loosen bolts evenly to prevent pressure plate damage.
Remove the bolts, clutch pressure plate, and clutch disc
4. CAUTION: Do not use cleaners with a petroleum base and do not immerse the clutch pressure plate in solvent.
Using a suitable commercial alcohol base solvent, clean the clutch pressure plate
5. Inspect the clutch pressure plate surface for burn marks, scores flatness or ridges
6. Inspect the clutch pressure plate diaphragm fingers for wear. Install a new clutch pressure plate as necessary
7. Measure the depth to the rivet heads. Install a new clutch disc if any rivet head measurement is not within specifications.
8. CAUTION: If the clutch disc is saturated with oil, inspect the rear engine crankshaft seal for leakage. If leakage is found, install a new seal prior
to clutch disc installation.
NOTE: Use an emery cloth to remove minor imperfections in the clutch disc lining surface. Install a new clutch disc if any of the following
conditions are present.
Inspect the clutch disc for:
^
oil or grease saturation
^
worn or loose facings
^
warpage or loose rivets at the hub
^
loose or broken torsion dampening springs
^
wear or rust on splines
