Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2. To remove the seal only, use the special tool and remove the stub shaft seal.
3. To remove the bearing and seal use the special tools and remove the stub shaft pilot bearing and seal.
Installation
1. NOTE: Lubricate the new stub shaft pilot bearing with rear axle lubricant.
To install the bearing, use the special tools and install the stub shaft pilot bearing.
2. NOTE: Lubricate the new stub shaft pilot bearing housing seal with grease.
To install the seal, use the special tools and install the stub shaft pilot bearing housing seal.
