Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2. CAUTION: Do not scratch the pinch weld area.
Trim the remaining urethane adhesive on the pinch weld to within the specification.
-
The existing urethane adhesive surface should be smooth and free of cuts and contamination.
3. CAUTION: Use caution when applying Urethane Metal Primer Essex U-413. Apply a light amount of primer. Too much primer will run
and damage the painted surface.
Use a wool applicator to apply Urethane Medal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow 6 to 10 minutes to dry.
4. Clean the inside of the quarter glass surface with alcohol-free cleaner, making sure the ceramic coated area is clean.
5. NOTE: Wipe off the glass prep immediately after each application because it flash dries.
Apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M5B280-C twice around the glass surface to urethaned.
6. Apply Glass Primer Essex U-402 meeting Ford specification WSB-M2G314-B to the same area that was prepped in the previous step. Allow five
minutes to dry.
7. Cut the urethane adhesive applicator tip to specification.
8. NOTE: Use caution when applying urethane adhesive. Apply to the outside edges of locating tabs on the glass surface.
Apply a bead of Urethane Adhesive Essex 400-HV or Essex U-216, which meets Ford specification WSB-M2G316-B. Start at the bottom and
work around to the sides of the quarter window glass.