Escape 4WD V6-3.0L (2008)
2. Remove the door handle screw.
3. Remove the door handle pull cup screw.
4. Remove the 3 door trim panel screws.
5. Remove the door trim panel.
-
Pull outward and then upward on the door trim panel.
-
Disconnect the electrical connector.
6. Remove the door handle from the door trim panel.
-
Press the 2 retaining tabs while pushing the door handle from the door trim panel.
-
Remove the door handle from the door trim panel by pulling it back through the door trim panel.
7. To install, reverse the removal procedure.
