Escape 4WD V6-3.0L (2008)
6. Install the RH outboard backrest-to-floor nut.
-
Tighten to 40 Nm (30 lb-ft).
Both rear seat backrests
7. Tighten the LH outboard backrest-to-floor nut.
-
Tighten to 40 Nm (30 lb-ft).
8. Position the carpet and install the 2 pin-type retainers.
9. Position upward and latch both rear backrests.
10. Install the LH outboard backrest-to-floor bolt.
-
Tighten to 40 Nm (30 lb-ft).
11. Install the center safety belt anchor bolt.
-
Tighten to 48 Nm (35 lb-ft).
RH rear seat backrest
12. Install the RH outboard backrest-to-floor bolt.
-
Tighten to 40 Nm (30 lb-ft).
13. Route the safety belt buckles through the elastic straps.
14. Position both rear seat cushions in place.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.