Escape 4WD V6-3.0L (2008)
4. NOTE: Note wiring harness routing for installation.
Detach the seat harness electrical connector and wiring harness from the seat track.
5. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm (17 lb-ft).
Heated seat
6. Disconnect and detach the cushion heater mat electrical connector.
7. Release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
8. Disconnect the heated seat relay electrical connector.
Seat with an original equipment OCS system
9. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
NOTE: To identify between a production OCS system and a OCS system service kit, inspect the OCSM electrical connector.
A production OCS system allows the disconnection of the OCSM electrical connector.
An OCS system service kit has the electrical connector glued to the module. It cannot and should not be disconnected or altered.
Disconnect the electrical connectors and wiring clips.
1
Disconnect the OCSM electrical connector.
2
Disconnect the pressure sensor electrical connector.
-
Release the 2 wiring clips on the wiring harness from the cushion frame.
10. CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn
from the seat cushion foam pad.
Release the cushion trim cover retainers and remove the cushion trim cover.
-
Separate the hook-and-loop strips.
11. Remove the cushion foam pad.
12. Bend the retaining tab away from the pressure sensor, then slide the pressure off the bracket.
