Escape 4WD V6-3.0L (2008)
Seat Cushion - Front, Passenger (Part 2)
Removal and Installation
WARNING:
-
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow
this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
-
Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat.
2. Remove the front seat backrest.
3. Remove the safety belt buckle pretensioner.
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
4. NOTE: Note wiring harness routing for installation.
Disconnect the electrical connectors, detach the wiring harness from the seat track.
-
If driver seat, disconnect the seat position sensor electrical connector.
-
If equipped, disconnect the power seat motor electrical connector.
-
Detach the seat harness electrical connector from the seat track.
5. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm (17 lb-ft).
6. To install, reverse the removal procedure.
-
Transfer components as necessary.
