Escape 4WD V6-3.0L (2008)
Trunk / Liftgate Switch: Service and Repair
Liftgate Release Switch
LIFTGATE RELEASE SWITCH
Removal and Installation
1. Remove the liftgate trim panel.
2. Remove the 4 liftgate trim bezel nuts and remove the bezel from the liftgate.
-
To install, tighten to 8 Nm (71 lb-in).
-
Disconnect the electrical connector.
-
Using the appropriate tool, press the tabs and remove the liftgate release switch.
3. To install, reverse the removal procedure.
