Escape 4WD V6-3.0L (2008)
Backing Plate: Service and Repair
Brake Backing Plate
Removal and Installation
1. Remove the rear wheel cylinder.
2. Remove the brake flexible hose bracket bolt.
^
To install, tighten to 17 Nm (13 lb-ft).
3. Compress the parking brake cable conduit locking tabs and pull the parking brake cable assembly through the backing plate.
4. Remove the rear wheel hub.
5. Remove the 4 backing plate bolts and the backing plate.
^
To install, tighten to 85 Nm (63 lb-ft).
6. To install, reverse the removal procedure.