Escape 4WD V6-3.0L (2008)
Disc Brake System - Exploded View
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
Hybrid vehicles
1. NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
Disconnect the battery.
2. Remove the battery junction box (BJB) fuses 24 (50A) and 31 (50A).
All vehicles
3. Remove the wheel and tire.
4. Remove and discard the brake flexible hose retaining clip.
5. Disconnect the brake tube fitting from the brake flexible hose.
^
To install, tighten to 15 Nm (11 lb-ft).
6. Detach the brake flexible hose from the strut bracket.
7. Disconnect the brake flexible hose from the caliper.
^
To install, tighten to 20 Nm (15 lb-ft).
8. To install, reverse the removal procedure.
^
Bleed the brake caliper.
