Escape 4WD V6-3.0L (2008)
3. CAUTION: Care must be taken during the removal of the grommet to prevent damage. If the grommet is damaged, a new sensor may
need to be installed, even though the sensor is functional in all other aspects.
Remove the grommet from the body.
^
When removing the body grommet, rotate the grommet into a position which allows the use of a small screwdriver to release the tabs on the
underside of the body grommet. These 2 tabs are located at right angles to the sensor wire.
4. Remove the front wheel speed sensor harness from the retainer.
5. Remove the front wheel speed sensor harness-to-body bolt.
^
To install, tighten to 9 Nm (80 lb-inch).
6. Remove the front wheel speed sensor harness-to-strut bracket bolt.
^
To install, tighten to 15 Nm (11 lb-ft).
7. Remove the front wheel speed sensor bolt from the wheel knuckle.
^
To install, tighten to 9 Nm (80 lb-inch).
8. NOTE: Clean off any foreign material that may have collected around the sensor before removal.
Remove the front wheel speed sensor.
9. NOTE: Thoroughly clean the mounting surface.
To install, reverse the removal procedure.
