Escape 4WD V6-3.0L (2008)
Front End Accessory Drive (FEAD) - Exploded View (Part 2)
Removal and Installation
All accessory drive belt idler pulleys
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
^
To install, tighten to 9 Nm (80 lb-in).
3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
LH accessory drive belt idler pulley
4. Remove the bolt and the LH accessory drive belt idler pulley.
^
To install, tighten to 47 Nm (35 lb-ft).
Center accessory drive belt idler pulley
5. Remove the bolt and the center accessory drive belt idler pulley.
^
To install, tighten to 25 Nm (18 lb-ft).
RH accessory drive belt idler pulley and bracket
6. Remove the 3 RH accessory drive belt idler pulley and bracket bolts. Then detach the wiring harness retainer and remove the idler pulley and
bracket assembly.
^
To install, tighten to 25 Nm (18 lb-ft).
All accessory drive belt idler pulleys
7. NOTE: Refer to the illustration for correct drive belt routing.
To install, reverse the removal procedure.
