Escape 4WD V6-3.0L (2008)
4. Remove the coolant pump belt.
5. Using the special tool, remove the coolant pump drive pulley.
6. Disconnect the heater hose from the coolant pump.
7. Disconnect the coolant pump-to-engine hose and position aside.
8. Remove the 3 bolts from the coolant pump assembly.
9. Reposition the coolant pump-to-thermostat housing hose clamp and remove the coolant pump and hose as an assembly.
Installation
1. Connect the coolant pump-to-thermostat housing hose and reposition the clamp.
2. Position the coolant pump assembly and install the 3 bolts.
^
Tighten to 10 Nm (89 lb-in).
^
Tighten the 3 bolts an additional 90 degrees.
3. Connect the coolant pump-to-engine hose and the heater hose.
4. NOTE: Install the coolant pump drive pulley flush with the end of the camshaft.
Using the special tool, install the coolant pump drive pulley.