Escape 4WD V6-3.0L (2008)
4. Remove the A/C compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
5. Detach the wire harness clip from the evaporator outlet line.
6. Remove the thermostatic expansion valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft).
7. Disconnect the low-charge protection switch electrical connector.
8. Detach the evaporator outlet line from the receiver/drier bracket.
9. Remove the evaporator outlet line.
10. To install, reverse the removal procedure.
-
Install new gasket seals and a new O-ring seal.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test and charge the refrigerant system.
