Escape 4WD V6-3.0L (2008)
18. Disconnect the driver side safety canopy module electrical connector.
19. From under the rear of the driver seat, slide and disengage the driver seat side air bag module electrical connector locking clip, and then release
the tab and disconnect the driver seat side air bag module electrical connector.
20. Install RCM fuse 32 (10A) to the SPDJB.
21. Connect the battery ground cable.
Reactivation
1. Remove RCM fuse 32 (10A) from the SPDJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Connect the driver seat side air bag module electrical connector and then slide and engage the seat side air bag electrical connector locking clip.
4. Connect the driver side safety canopy module electrical connector.
