Escape 4WD V6-3.0L (2008)
instruction may result in serious personal injury.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure.
2. Squeeze the quick connect coupling retainer clip tabs to release the locking mechanism.
3. NOTE: When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube.
Disconnect the quick connect coupling from the tube.
-
Push the locking mechanism outward to release the quick connect coupling.
-
Pull on the quick connect coupling and separate it from the tube.
Connect - Type IV
1. NOTE:
-
Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
-
Make sure the tube clicks into place when installing into the quick connect coupling. To make sure that the tube is fully seated, pull on the
tube.
Connect the quick connect coupling to the tube.
1
Install the quick connect coupling onto the tube until it is fully seated.
2
Depress the locking tab until it is flush with the quick connect coupling housing.
