Escape 4WD V6-3.0L (2008)
7. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip. The hook-and-loop strip can be torn
from the seat backrest foam pad. Failure to follow this instruction may result in component damage and/or system failure.
Place a hand between the seat backrest trim cover and the seat backrest foam pad and carefully separate the hook-and-loop strips.
8. Carefully roll up the seat back trim cover in an inside out fashion to the side air bag module.
9. Release the side air bag module deployment chute J-clip from around the side air bag module.
10. Feed the side air bag module deployment chute and J-clips out through the side air bag module seat backrest foam opening.
11. Continue to roll the seat backrest trim cover up to access the side air bag module.
12. Detach the 2 side air bag module wiring harness retainers from the seat backrest frame.
13. Through the back of the seat backrest, position out the seat backrest foam pad. Then remove the 2 side air bag module nuts and remove the side air
bag module.
